Toyota Venza manuals

Toyota Venza: Inspection

INSPECTION

PROCEDURE

1. INSPECT FRONT SEATBACK HEATER LH

(a) Apply battery voltage and check the seatback heater.

OK:

Measurement Connection

Condition

Specified Condition

Battery positive (+) → Terminal 1

Battery negative (-) → Terminal 2

Always

Seatback heater becomes warm

Text in Illustration

*1

Component without harness connected

(Front Seatback Heater)

If the result is not as specified, replace the front seatback heater.

NOTICE:

Immediately after confirming that the seat heater is functioning normally, remove the battery leads. Failing to do so may cause the seat heater to overheat.


Removal
REMOVAL PROCEDURE 1. REMOVE FRONT SEAT HEADREST ASSEMBLY 2. REMOVE FRONT SEAT REAR OUTER TRACK COVER 3. REMOVE FRONT SEAT REAR INNER TRACK COVER 4. REMOVE FRONT SEAT ASSEMBLY 5. REMOVE ...

Installation
INSTALLATION PROCEDURE 1. INSTALL SEPARATE TYPE FRONT SEATBACK COVER (a) Using a tacker, install the separate type front seatback heater to the end of the separate type front seatbac ...

Other materials about Toyota Venza:

Removal
REMOVAL PROCEDURE 1. PRECAUTION (w/ Navigation System) NOTICE: After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the ...

Operation Check
OPERATION CHECK 1. AUTOMATIC LIGHT CONTROL SYSTEM OPERATION CHECK (a) Turn the ignition switch to ON. (b) Turn the light control switch to the AUTO position. (c) Cover the automatic light control sensor. (d) Check that the taillights and low beam headligh ...

Vehicle Speed Signal Malfunction (C1541)
DESCRIPTION The power steering ECU receives vehicle speed signals from the brake actuator assembly (skid control ECU) via CAN communication. The ECU provides appropriate assisting force in accordance with the vehicle speed, based on the signals. ...

© 2016-2026 Copyright www.tovenza.com

0.1186