Toyota Venza: Do-it-yourself maintenance

Emission inspection and maintenance (I/M) programs

Some states have vehicle emission inspection programs which include OBD (On Board Diagnostics) checks. The OBD system monitors the operation of the emission control system.  - If the malfunc ...

Do-it-yourself service precautions

If you perform maintenance yourself, be sure to follow the correct procedure given in these sections. CAUTION The engine compartment contains many mechanisms and fluids that may move suddenly, ...

Other materials about Toyota Venza:

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL MAGNETIC CLUTCH ASSEMBLY (a) Install the magnetic clutch stator while aligning the protrusion on the stator with the notch on the air compressor assembly as shown in the illustration. ...

Test Mode Procedure
TEST MODE PROCEDURE 1. ENTER TEST MODE (SIGNAL CHECK MODE) (a) Turn the ignition switch off. (b) Connect the Techstream to the DLC3. (c) Turn the ignition switch to ON. (d) Check that the tire pressure warning light comes on for 3 seconds and then goes ...

Inspection
INSPECTION PROCEDURE 1. INSPECT INTEGRATION RELAY (a) Inner circuit (for 2GR-FE) (1) for EFI MAIN relay Measure the resistance according to the value(s) in the table below. Standard Resistance: ...