Toyota Venza: Instrument Panel Speaker

Front Door Speaker

Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the n ...

Components

COMPONENTS ILLUSTRATION ...

Other materials about Toyota Venza:

Inspection
INSPECTION PROCEDURE 1. INSPECT CYLINDER BLOCK FOR WARPAGE (a) Using a precision straightedge and feeler gauge, check the surface that is in contact with the cylinder head gasket for warpage. Maximum Warpage: 0.05 mm (0.00197 in.) I ...

Initialization
INITIALIZATION 1. RESET BACK DOOR CLOSE POSITION NOTICE: Perform initialization of the power back door system (power back door ECU initialization) if one of the following is performed: The cable is disconnected from the negative (-) battery termin ...

Installation
INSTALLATION PROCEDURE 1. INSTALL SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY (a) Install the spiral with sensor cable sub-assembly (See page ). NOTICE: Do not replace the spiral cable with the battery connected and the engine switch on (IG). ...