Toyota Venza manuals

Toyota Venza: Installation

INSTALLATION

PROCEDURE

1. INSTALL FRONT NO. 3 SPEAKER ASSEMBLY (for 13 Speakers)

(a) Engage the 3 claws to install the front No. 3 speaker assembly.


2. INSTALL FRONT PILLAR GARNISH CORNER PIECE (for 13 Speakers)


3. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY

(a) Connect the connector.


(b) Install the front No. 2 speaker assembly with the 2 bolts.

Torque:

11 N·m {112 kgf·cm, 8 ft·lbf}


4. INSTALL NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY


5. INSTALL FRONT NO. 4 SPEAKER ASSEMBLY (for 13 Speakers)

(a) Connect the connector.


(b) Install the center speaker assembly with the 2 bolts.

Torque:

11 N·m {112 kgf·cm, 8 ft·lbf}

6. INSTALL NO. 2 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY


7. INSTALL FRONT PILLAR GARNISH


8. CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP


Inspection
INSPECTION PROCEDURE 1. INSPECT FRONT NO. 2 SPEAKER ASSEMBLY (for 6 Speakers) (a) With the speaker installed, check that there is no looseness or other abnormalities. (b) Check that there is no fo ...

Luggage Speaker
...

Other materials about Toyota Venza:

Panel Switches do not Function
PROCEDURE 1. CHECK PANEL SWITCH (a) Check for foreign matter around the switches that might prevent operation. OK: No foreign matter is found. NG REMOVE ANY FOREIGN MATTER FOUND ...

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL REAR STRUT ROD ASSEMBLY (for 2WD) (a) Temporarily install the ...

Low Battery Positive Voltage or Abnormally High Battery Positive Voltage (C1241/41)
DESCRIPTION If a malfunction is detected in the power supply circuit, the skid control ECU (housed in the actuator assembly) stores this DTC and the fail-safe function prohibits ABS operation. This DTC is stored when the IG1 terminal voltage deviates fro ...

© 2016-2026 Copyright www.tovenza.com

0.1371