Toyota Venza manuals

Toyota Venza: Dtc Check / Clear

DTC CHECK / CLEAR

1. CHECK DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Smart Key / Trouble Codes.

(e) Check the details of the DTC(s) (See page ).


2. CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Smart Key / Trouble Codes.

(e) Clear the DTCs.

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) (a) Disconnect the D25 certification ECU (smart key ECU assembly) connector. (b) Measure the voltage and resistance according ...

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any p ...

Other materials about Toyota Venza:

Sliding Roof Switch Assembly
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE MAP LIGHT ASSEMBLY Inspection INSPECTION PROCEDURE 1. INSPECT SLIDING ROOF SWITCH (ROOF CONSOLE BOX ASSEMBLY) (a) Measure the resistance according to the value(s) in ...

Reassembly
REASSEMBLY CAUTION / NOTICE / HINT NOTICE: Before installation, apply high temperature grease to the parts indicated by arrows (See page ). PROCEDURE 1. INSTALL NO. 2 PARKING BRAKE SHOE HOLD DOWN SPRING PIN (for 2WD) (a) Install the No. 2 p ...

Sliding Roof ECU Communication Stop (B1273)
DESCRIPTION This DTC is stored when LIN communication between the sliding roof ECU (sliding roof drive gear sub-assembly) and main body ECU (driver side junction block assembly) stops for more than 10 seconds. DTC No. DTC Detection ...

© 2016-2026 Copyright www.tovenza.com

0.1258