Toyota Venza: Clock System

Accessory Meter

Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL ACCESSORY METER ASSEMBLY (w/o Rear View Monitor System) (a) Connect the connector. ...

Parts Location

PARTS LOCATION ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Adjustment
ADJUSTMENT PROCEDURE 1. INSPECT AND ADJUST BRAKE PEDAL HEIGHT (a) Check the brake pedal height. (1) Turn back the carpet. (2) Measure the brake pedal height from the dash panel to the bottom edge of the brake pedal pad. Text in Illustrat ...

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT CENTER AIRBAG SENSOR ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION) (a) Perform a diagnostic system check (See page ). 2. INSPECT CENTER AIRBAG SENSOR ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT D ...

Removal
REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY 3. REMOVE COOL AIR ...