Toyota Venza: Automatic Transaxle Unit

ECU Power Source Circuit

DESCRIPTION When the ignition switch is turned to ON, voltage from the ECM's MREL terminal is applied to the EFI MAIN relay. This causes the contacts of the EFI MAIN relay to close, which sup ...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Automatic High Beam
The Automatic High Beam uses an in-vehicle camera sensor to assess the brightness of streetlights, the lights of oncoming and preceding vehicles, etc., and automatically turns high beam on or off as necessary.  - Activating the Automatic High Beam sy ...

Installation
INSTALLATION CAUTION / NOTICE / HINT NOTICE: Always use a new grommet and valve core when installing the tire pressure warning valve and transmitter. Check that the washer and nut are not damaged, and replace them if necessary. Write ...

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure described below is for the LH side. PROCEDURE 1. PRECAUTION (for HID Headlight) (See page ) NOTICE: After turning the ignition switch ...