Toyota Venza: 1ar-fe Lubrication

Installation

INSTALLATION PROCEDURE 1. INSTALL VACUUM SWITCHING VALVE ASSEMBLY (for ACIS) (a) Install the vacuum switching valve assembly (for ACIS) with the bolt. Torque: 9.0 N·m {92 kgf·cm ...

Engine Oil Cooler

Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE EXHAUST MANIFOLD ASSEMBLY HINT: See page 2. DRAIN ENGINE OIL 3. DRAIN ENGINE COOLANT 4. REMOVE OIL COOLE ...

Other materials about Toyota Venza:

Test Mode Procedure
TEST MODE PROCEDURE 1. ENTER TEST MODE (SIGNAL CHECK MODE) (a) Turn the ignition switch off. (b) Connect the Techstream to the DLC3. (c) Turn the ignition switch to ON. (d) Check that the tire pressure warning light comes on for 3 seconds and then goes ...

Adjustment
ADJUSTMENT PROCEDURE 1. INSPECT SHIFT LEVER POSITION (a) When moving the lever from P to R with the ignition switch ON and the brake pedal depressed, make sure that the shift lever moves smoothly and moves correctly into position. (b) Start the engine ...

Front Power Seat does not Operate with Front Power Seat Switch
DESCRIPTION Signals are input into the position control ECU and switch assembly. The built-in ECU manages the signals received from the position control ECU and switch assembly, and operates each motor. If the position control ECU and switch assembly rece ...