Toyota Venza: Installation
INSTALLATION
PROCEDURE
1. INSTALL VACUUM SWITCHING VALVE ASSEMBLY (for ACIS)
|
(a) Install the vacuum switching valve assembly (for ACIS) with the bolt. Torque: 9.0 N·m {92 kgf·cm, 80 in·lbf} |
|
.png)
(b) Connect the 2 vacuum hoses, clamp and connector.
2. INSTALL OUTER COWL TOP PANEL
.gif)
3. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
4. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
5. INSTALL FRONT FENDER TO COWL SIDE SEAL LH
6. INSTALL FRONT FENDER TO COWL SIDE SEAL RH
7. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH
8. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH
9. INSTALL FRONT WIPER ARM HEAD CAP
10. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT WIPER ARM HEAD CAP
2. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH
3. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH
4. REMOVE FRONT FENDER TO COWL SIDE S ...
Other materials about Toyota Venza:
Assist Map Number Mismatch (C1582)
DESCRIPTION
When an incorrect ECM or brake actuator assembly (skid control ECU) is installed
after the assist map has been recorded in the power steering ECU, then DTC C1582
is stored because the data does not match the vehicle specifications.
...
Dtc Check / Clear
DTC CHECK / CLEAR
1. DTC CHECK (USING SST CHECK WIRE)
(a) Check the DTCs (Current trouble codes).
(1) Turn the ignition switch to ON, and wait for approximately 60 seconds.
(2) Using SST, connect terminals TC and CG of the DLC3.
SST: 09843-18040
NOTICE ...
Certification ECU Communication Stop Mode
DESCRIPTION
Detection Item
Symptom
Trouble Area
Certification ECU Communication Stop Mode
"Smart Access/Smart Key/Wireless Tuner" is not displayed on
"CAN Bus Check&q ...
0.1256