Toyota Venza manuals

Toyota Venza: Tire Pressure Warning Valve

Toyota Venza Service Manual / Tire Pressure Monitoring / Tire Pressure Warning Valve

TC and CG Terminal Circuit
DESCRIPTION DTC output mode is set by connecting terminals 13 (TC) and 4 (CG) of the DLC3. The DTCs are indicated by the blinking pattern of the tire pressure warning light. WIRING DIAGRAM HINT ...

Components
COMPONENTS ILLUSTRATION ...

Other materials about Toyota Venza:

Reassembly
REASSEMBLY CAUTION / NOTICE / HINT HINT: Perform "Inspection After Repair" after replacing the cylinder head sub-assembly (See page ). PROCEDURE 1. INSTALL SPARK PLUG TUBE HINT: When using a new cylinder head, the spark plug tubes must be r ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL FRONT OIL PUMP OIL SEAL (a) Using SST and a hammer, install a new oil seal to the oil pump body. SST: 09350-32014 09351-32140 Oil seal driven in depth: -0.25 to 0.25 mm (-0.00984 to 0.00984 in.) ...

Oxygen (A/F) Sensor Signal Stuck Lean (Bank 1 Sensor 1) (P2195,P2196)
DESCRIPTION HINT: Although the DTC titles say oxygen sensor, these DTCs relate to the air fuel ratio sensor. Sensor 1 refers to the sensor mounted in front of the three-way catalytic converter and located near the engine assembly. ...

© 2016-2026 Copyright www.tovenza.com

0.1567