Toyota Venza: System Diagram

Parts Location

PARTS LOCATION ILLUSTRATION ...

On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. PERFORM SPARK TEST (a) Check for DTCs (See page ). NOTICE: If any DTC is output, perform troubleshooting procedures for that DTC. (b) Remove the ignition coil ...

Other materials about Toyota Venza:

System Description
SYSTEM DESCRIPTION 1. GENERAL (a) To assist the driver with parking the vehicle by displaying an image of the area behind the vehicle, this system has a rear television camera assembly mounted on the back door. The system displays the image on the naviga ...

Detection range of the sensors
1. Approximately 1.6 ft. (50 cm) 2. Approximately 4.9 ft. (150 cm) 3. Approximately 2.0 ft. (60 cm) The diagram shows the detection range of the sensors. Note that the sensors cannot detect obstacles that are extremely close to the vehicle. The range o ...

ABS Malfunction (C1296/96)
DESCRIPTION If a malfunction in the speed sensor signal circuit occurs, the AWD control ECU will output this DTC. DTC No. DTC Detecting Condition Trouble Area C1296/96 When condition is met: ...