Toyota Venza: System Description
SYSTEM DESCRIPTION
1. FRONT POWER SEAT CONTROL SYSTEM DESCRIPTION
The driver seat is equipped with slide, reclining, lifter, front vertical and lumbar support adjustment functions.
2. FUNCTION OF MAIN COMPONENTS
The following functions are available:
|
Components |
Function |
|---|---|
|
Front seat assembly (slide motor) |
Activated based on a signal from the power seat switch, a motor is activated and slides the seat forward and rearward. |
|
Front seat assembly (reclining motor) |
Activated based on a signal from the power seat switch, a motor is activated and tilts and reclines the seat. |
|
Power seat motor assembly (front vertical motor) |
Activated based on a signal from the power seat switch and raises and lowers the seat cushion front vertically. |
|
Front seat assembly (lifter motor) |
Activated based on a signal from the power seat switch and raises and lowers the seat vertically. |
|
Lumbar support adjuster assembly |
Activated based on a signal from the front power seat lumbar switch and adjusts lumbar support. |
Parts Location
PARTS LOCATION
ILLUSTRATION
ILLUSTRATION
...
System Diagram
SYSTEM DIAGRAM
...
Other materials about Toyota Venza:
Installation
INSTALLATION
PROCEDURE
1. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
(a) Align the splines of the shaft and install the drive shaft assembly
LH using a brass bar and a hammer.
NOTICE:
Set the shaft snap ring with the opening fac ...
Rear Stabilizer Bar(for 2wd)
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE REAR WHEELS
2. REMOVE REAR STABILIZER LINK ASSEMBLY LH
(a) Remove the nut and separate the rear stabilizer link assembly LH
from the rear stabil ...
ECM Communication Stop Mode
DESCRIPTION
Detection Item
Symptom
Trouble Area
ECM Communication Stop Mode
"Engine" and "ECT" are not displayed on "CAN Bus Check" screen
of the Techs ...
0.1284