Toyota Venza: Customize Parameters

Toyota Venza Service Manual / Theft Deterrent / Keyless Entry / Theft Deterrent System(w/o Smart Key System) / Customize Parameters

CUSTOMIZE PARAMETERS

HINT:

The following items can be customized.

NOTICE:

After confirming whether the items requested by the customer are applicable or not for customization, perform customizing operations.
Be sure to record the current settings before customization.
When troubleshooting, make sure that the item in question is not set to OFF as a result of customization (Example: For the system, "the wireless function does not operate", first check that the wireless function is not set to OFF, then perform troubleshooting).

1. CUSTOMIZE

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(d) Enter the following menus: Customize Setting /

(e) Select the setting by referring to the table below.

Security

Display (Item)	Default	Content	Setting
Warning by Horn	ON	Function that allows the vehicle horn and theft deterrent horn to be used as warning devices	ON or OFF
Passive Mode (Security System)	OFF	Passive Mode is a function that switches the theft deterrent system from the arming preparation state to the armed state 30 seconds after the key is removed from the key cylinder and all doors, engine hood and back door are closed, even if the doors are not locked by wireless or door key lock operation. In Passive Mode, if the following operations are not performed within 14 seconds after a door is opened during armed state, the theft deterrent system will judge that condition as a theft and switch to the alarm sounding state. Unlock any door by key or wireless operation Turn the ignition switch to ON	ON or OFF
Entry Delay	14 s	Function that changes entry delay time (time before warning starts) for Passive Mode	0 s, 14 s or 30 s

How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT HINT: Use this procedure to troubleshoot the theft deterrent system. *: Use the Techstream. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHO ...

Problem Symptoms Table

PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are lis ...

Other materials about Toyota Venza:

Certification Ecu
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system. N ...

System Diagram
SYSTEM DIAGRAM Communication Table Transmitting ECU (Transmitter) Receiving ECU (Receiver) Signal Communication Method Certification ECU (smart key ECU assembly) Power management contro ...

Inside Vehicle
General Maintenance GENERAL MAINTENANCE CAUTION / NOTICE / HINT These are maintenance and inspection items that are considered to be the owner's responsibility. The owner can do them or they can have them done at a service center. The ...