Toyota Venza: Steering Column Assembly

Steering Column

...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Installation
INSTALLATION PROCEDURE 1. INSTALL SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY (a) Install the spiral with sensor cable sub-assembly (See page ). NOTICE: Do not replace the spiral cable with the battery connected and the engine switch on (IG). ...

Door Mirror Foot Light
Components COMPONENTS ILLUSTRATION Removal REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for both the RH and LH sides. The procedure described below is for the LH side. PROCEDURE 1. REMOVE OUTER MIRROR 2. REM ...

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) (a) Disconnect the P4 ECU connector. (b) Measure the resistance and voltage according to the value(s) in the table below. HINT: Measure the values on the wire harness si ...