Toyota Venza manuals

Toyota Venza: Skid Control ECU Malfunction (C1300/62)

DESCRIPTION

The skid control ECU outputs this DTC, if malfunctions are found in the circuit inside the ECU by self diagnosis.

DTC Code

DTC Detection Condition

Trouble Area

C1300/62

Internal failure of the skid control ECU control unit.

Brake actuator assembly (Skid control ECU)

PROCEDURE

1.

REPLACE BRAKE ACTUATOR ASSEMBLY

(a) Replace the brake actuator assembly (skid control ECU) (See page ).


HINT:

This DTC is output when the skid control ECU detects a malfunction in the internal circuit.


NEXT

END

Stop Light Control Relay Malfunction (C1380/64)
DESCRIPTION Upon receiving the hill-start assist control operating signal from the skid control ECU, the relay contact turns on and the stop light comes on. DTC Code DTC Dete ...

Brake Pedal Load Sensing Switch (C1267/67)
DESCRIPTION The brake pedal load sensing switch is turned on when the brake pedal is depressed with force exceeding a predetermined level. The skid control ECU detects if the brake pedal is depres ...

Other materials about Toyota Venza:

Center Airbag Sensor Communication Stop Mode
DESCRIPTION Detection Item Symptom Trouble Area Center Airbag Sensor Communication Stop Mode "SRS Airbag" is not displayed on "CAN Bus Check" screen of the Techs ...

Vehicle Speed Signal Error (Test Mode DTC) (C2191/91)
DESCRIPTION The tire pressure warning ECU receives a vehicle speed signal from the combination meter. This DTC is stored upon entering signal check mode (test mode), and cleared when a vehicle speed signal of 20 km/h (12 mph) is detected for 3 seconds or ...

Installation
INSTALLATION PROCEDURE 1. INSTALL WATER PUMP ASSEMBLY (a) Install a new gasket and the water pump with the 7 bolts. Torque: 21 N·m {214 kgf·cm, 15 ft·lbf} 2. INSTALL V-RIBBED BELT TENSIONE ...

© 2016-2026 Copyright www.tovenza.com

0.1734