Toyota Venza: Reassembly

Toyota Venza Service Manual / Steering Gear / Linkage / Steering Gear(when Using The Engine Support Bridge For Awd) / Reassembly

REASSEMBLY

PROCEDURE

1. INSTALL NO. 2 STEERING RACK BOOT

(a) Apply lithium soap base glycol grease to the inside of the small opening of a new No. 2 steering rack boot.

(b) Install the No. 2 steering rack boot to the groove on the rack housing.

NOTICE:

Be careful not to damage or twist the boot.
Make sure that the boot is free of rust and foreign matter.

2. INSTALL NO. 1 STEERING RACK BOOT

HINT:

Perform the same procedure as for the No. 2 steering rack boot.

3. INSTALL NO. 2 STEERING RACK BOOT CLAMP

(a) Using SST, tighten a new No. 2 steering rack boot clamp as shown in the illustration.

SST: 09521-24010

Clearance:

3.0 mm (0.118 in.) or less

NOTICE:

Be careful not to damage or twist the boot.

4. INSTALL NO. 1 STEERING RACK BOOT CLAMP

HINT:

Perform the same procedure as for the No. 2 steering rack boot clamp.

SST: 09521-24010

5. INSTALL STEERING RACK BOOT CLIP (for LH Side)

(a) Using pliers, install the steering rack boot clip.

6. INSTALL STEERING RACK BOOT CLIP (for RH Side)

HINT:

Perform the same procedure as for the LH side.

7. INSPECT STEERING GEAR ASSEMBLY

(a) Using SST, rotate the pinion shaft to see if both the left and the right steering rack boots expand and contract smoothly.

SST: 09616-00020

HINT:

If the operation cannot be done as specified, use new steering rack boot clamps and reinstall the steering rack boots.

Inspection

INSPECTION PROCEDURE 1. INSPECT TIE ROD ASSEMBLY LH (a) Secure the tie rod assembly LH in a vise. (b) Install the nut to the stud bolt. ( ...

Installation

INSTALLATION CAUTION / NOTICE / HINT NOTICE: When disconnecting the steering intermediate shaft assembly and pinion shaft of steering gear assembly, be sure to place matchmarks before servicing. ...

Other materials about Toyota Venza:

Antenna Coil Open / Short (B2784)
DESCRIPTION The transponder key coil is built into the transponder key amplifier and receives a key code signal from the transponder chip in the key. This signal is amplified by the amplifier, then it is output to the transponder key ECU assembly. ...

Fuel Sender Open Detected (B1500)
DESCRIPTION This DTC is output when the combination meter assembly detects a fuel sender gauge malfunction via the direct line. DTC No. DTC Detection Condition Trouble Area B1500 When either of t ...

Window Defogger Wire
On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. CHECK REAR WINDOW DEFOGGER SYSTEM OPERATION (a) When the ignition switch is turned to ON and the rear window defogger switch is pressed, check that the rear window defogger system operates. 2. I ...