Toyota Venza manuals

Toyota Venza: Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART

If a trouble code is displayed during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the ''See page'' below.

Front Power Seat Control System (w/ Memory)

DTC Code

Detection Item

See page

B2650

Slide Sensor Malfunction


B2658

Short in Sensor with Motor Power Supply Circuit


Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any p ...

Slide Sensor Malfunction (B2650)
DESCRIPTION When the position control ECU and switch assembly does not receive a sensor signal despite forward or backward movement of seat by power seat motor operation, this DTC is output. ...

Other materials about Toyota Venza:

Installation
INSTALLATION PROCEDURE 1. INSTALL REAR SEAT ASSEMBLY RH (a) Place the rear seat assembly RH in the cabin. NOTICE: Be careful not to damage the vehicle body. (b) Temporarily install the 2 bolts on the front side of the seat. ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL NO. 1 CENTER SUPPORT BEARING ASSEMBLY (a) Set the No. 1 center support bearing on the intermediate shaft as shown in the illustration. NOTICE: Make sure to install the bearing in the correct position. ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL NO. 1 INSTRUMENT PANEL PIN (a) Install the 2 No. 1 instrument panel pins with the 2 screws <E> or <F>. 2. INSTALL GLOVE BOX LIGHT ASSEMBLY ...

© 2016-2026 Copyright www.tovenza.com

0.158