Toyota Venza: Rear Combination Light Assembly

Diagnosis Circuit

DESCRIPTION The headlight leveling ECU assembly outputs DTC information to the Techstream via this circuit. WIRING DIAGRAM PROCEDURE 1. CHECK HARNESS AND CONNECTOR (DLC3 ...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Sound Quality is Bad Only when CD is Played (Volume is Too Low)
PROCEDURE 1. REPLACE CD AND RECHECK (a) Replace the CD with a known good one and check that the malfunction disappears. OK: Malfunction disappears. OK END NG REPLACE RADIO AN ...

Internal Control Module Accelerator Pedal Position Performance (P060D)
MONITOR DESCRIPTION The ECM monitors the input signals of the accelerator pedal position sensor No. 1. When the input signals and control signals are deviated, the DTC is stored. DTC No. DTC Detection Condition Trouble Area ...

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. CONNECT TECHSTREAM (a) Connect the Techstream to the DLC3. (b) Start the engine and run it at idle. (c) Enter the following menus: Chassis / ABS/VSC/TRAC / Active Test. HINT: Refer to the Techstream operator's manu ...