Toyota Venza: Outer Mirror Switch

Outer Mirror Control Ecu

Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG 2. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMRE ...

Components

COMPONENTS ILLUSTRATION ...

Other materials about Toyota Venza:

Removal
REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system. NOTICE: When disconnecting the cable, some systems ne ...

Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART If a trouble code is displayed during the DTC check, check the circuit listed for the code in the table below (proceed to the page listed for that circuit). HINT: When DTC B1650/32 is detected as a result of troubleshooting f ...

Power Source Mode does not Change to ON (ACC)
DESCRIPTION When the engine switch is pushed with the electrical key in the cabin, the power management control ECU receives signals to change the power source mode. HINT: To allow use of the Techstream to inspect the push-button start function when the ...