Toyota Venza: Integration Relay

Power Distribution

Components

Other materials about Toyota Venza:

Relay
On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT HORN RELAY (ENGINE ROOM JUNCTION BLOCK ASSEMBLY) (a) Remove the engine room junction block assembly from the engine room relay block (See page ). ...

Mass or Volume Air Flow Circuit Low Input (P0102,P0103)
DESCRIPTION The mass air flow meter is a sensor that measures the amount of air flowing through the throttle valve. The ECM uses this information to determine the fuel injection time and to provide the appropriate air-fuel ratio. Inside the mass air flow ...

Removal
REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system (See page ). NOTICE: When disconnecting the cable, s ...