Toyota Venza: Front Speed Sensor

Brake Pedal Load Sensing Switch

On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT BRAKE PEDAL LOAD SENSING SWITCH NOTICE: Do not remove the brake pedal load sensing switch from the brake pedal suppo ...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Installation
INSTALLATION PROCEDURE 1. INSTALL WATER PUMP ASSEMBLY (a) Install a new gasket and the water pump with the 7 bolts. Torque: 21 N·m {214 kgf·cm, 15 ft·lbf} 2. INSTALL V-RIBBED BELT TENSIONE ...

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL REAR AIRBAG SENSOR (a) Check that the ignition switch is off. (b) Check ...

Adjustment
ADJUSTMENT PROCEDURE 1. INSPECT TIRES (a) Inspect the tires (See page ). 2. MEASURE VEHICLE HEIGHT NOTICE: Before inspecting the wheel alignment, adjust the vehicle height to the specified value. Be sure to perform measurement on a level ...