Toyota Venza: Center Airbag Sensor Assembly

TC and CG Terminal Circuit

DESCRIPTION DTC output mode is set by connecting terminals TC and CG of the DLC3. DTCs are displayed by blinking of the SRS warning light. HINT: When each warning light stays blinking, a g ...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

On-vehicle Inspection
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT CAUTION: Be sure to follow the correct removal and installation procedures of the rear airbag sensor. PROCEDURE 1. INSPECT REAR AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION) (a) Perform a diagnostic sys ...

Electrical Key Oscillator(for Front Floor)
Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL ELECTRICAL KEY OSCILLATOR (a) Engage the clamp and install the electrical key oscillator. NOTICE: Be careful when installing the electrical key osci ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE SEAT ADJUSTER COVER CAP (a) Remove the seat adjuster cover cap. HINT: Use the same procedure for the RH side and LH side. 2. REMOVE RECLINING POWER SEAT SWITCH ...