Toyota Venza: Using the automatic mode
Press
.
The air conditioning system will begin to operate. In outside air or recirculated air mode, air outlets, fan speed and air conditioning on/ off are automatically adjusted according to the temperature setting.
“AUTO” will be displayed on the multi-information display, along with the
temperature setting. The settings that are automatically adjusted by the system
are not displayed. When only “AUTO” and the temperature settings are displayed,
may be pressed a second time to temporarily
display all system settings.
Turn the temperature control dial
clockwise (warm) or counterclockwise (cool).
The temperature for the driver’s and front passenger’s seats can be set separately.
Turn the temperature control dial clockwise (warm) or counterclockwise (cool).
The temperature for the driver’s and front passenger’s seats can be set separately.
Automatic air conditioning system
Airflow and outlets are automatically adjusted according to the temperature
setting.
► Control panel
► Multi-information display (TFT type)
The settings display will differ ...
Adjusting the settings
- Adjusting the temperature setting
Turn the temperature control dial clockwise (warm) or counterclockwise (cool).
The air conditioning system switches between dual and simultaneous modes each ...
Other materials about Toyota Venza:
Erasing the entire HomeLink® memory (all three programs)
Press and hold the 2 outside buttons for 10 seconds (or 20 seconds depending
on the model) until the indicator light flashes.
If you sell your vehicle, be sure to erase the programs stored in the HomeLink®
memory.
- Before programming
• Insta ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT EVAPORATOR TEMPERATURE SENSOR
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
...
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT DRIVER SIDE SEAT BELT WARNING
(a) Turn the ignition switch to ON.
(b) When the driver side seat belt is not fastened, check that the driver side
seat belt warning light on the combination meter assembly blinks.
...
0.1519