Toyota Venza: Removal

Toyota Venza Service Manual / Seat / Power Seat Switch / Removal

REMOVAL

PROCEDURE

1. REMOVE FRONT SEAT HEADREST ASSEMBLY

2. REMOVE FRONT SEAT REAR OUTER TRACK COVER

3. REMOVE FRONT SEAT REAR INNER TRACK COVER

4. REMOVE FRONT SEAT ASSEMBLY

5. REMOVE RECLINING POWER SEAT SWITCH KNOB

6. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

7. REMOVE FRONT SEAT CUSHION SHIELD ASSEMBLY

8. REMOVE POWER SEAT SWITCH

(a) Disconnect the connector.

(b) Remove the 3 screws and the power seat switch.

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ...

Inspection

INSPECTION PROCEDURE 1. INSPECT FRONT POWER SEAT SWITCH LH (w/o Seat Position Memory System) (a) Measure the resistance between the terminals when each switch is operated. Standar ...

Other materials about Toyota Venza:

Reassembly
REASSEMBLY CAUTION / NOTICE / HINT HINT: Perform "Inspection After Repair" after replacing the piston or piston ring (See page ). PROCEDURE 1. INSTALL STUD BOLT NOTICE: If a stud bolt is deformed or the threads are damaged, replace it. (a) ...

Check CAN Bus Line for Short to GND
DESCRIPTION There may be a short circuit between the CAN bus main wire and GND when there is no resistance between terminals 6 (CANH) and 4 (CG) or 14 (CANL) and 4 (CG) of the DLC3. Symptom Trouble Area No resistanc ...

Adjustment
ADJUSTMENT PROCEDURE 1. INSPECT AND ADJUST BRAKE PEDAL HEIGHT (a) Check the brake pedal height. (1) Turn back the carpet. (2) Measure the brake pedal height from the dash panel to the bottom edge of the brake pedal pad. Text in Illustrat ...