Toyota Venza: Removal

Toyota Venza Service Manual / Window / Glass / Power Window Regulator Motor(for Front Door) / Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.

PROCEDURE

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system (See page ).

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG

3. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

4. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

5. REMOVE COURTESY LIGHT ASSEMBLY

6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

7. REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY

8. REMOVE DOOR SIDE AIRBAG SENSOR

9. REMOVE FRONT DOOR SERVICE HOLE COVER

10. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

11. REMOVE FRONT DOOR WINDOW REGULATOR ASSEMBLY

12. REMOVE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY

(a) Using a T25 "TORX" driver, remove the 3 screws and the front power window regulator motor assembly.

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ...

Inspection

INSPECTION PROCEDURE 1. INSPECT FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (a) Apply positive (+) battery voltage to connector terminal 2 (B). NOTICE: Do not apply positive (+) ...

Other materials about Toyota Venza:

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column ...

Radio Antenna
Components COMPONENTS ILLUSTRATION ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL RADIO ANTENNA ASSEMBLY (a) Engage the 2 claws to install the radio antenna assembly. (b) Place the antenna cord in the cutout of the ante ...

Pressure Control Solenoid "A" Electrical (Shift Solenoid Valve SL1) (P0748)
DESCRIPTION Changing from 1st to 6th is performed by the TCM turning shift solenoid valves SL1, SL2, SL3, SL4 and SL on and off. If an open or short circuit occurs in any of the shift solenoid valves, the TCM controls the remaining normal shift solenoid ...