Toyota Venza: Screen Flicker or Color Distortion

Toyota Venza Service Manual / Audio / Video / Audio And Visual System / Screen Flicker or Color Distortion

PROCEDURE

1.	CHECK DISPLAY SETTING

(a) Reset display settings (contrast, brightness) and check that the screen appears normal.

OK:

The display returns to normal.

END

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Touch Panel Switch does not Function

PROCEDURE 1. CHECK MULTI-DISPLAY (a) Check if there is any foreign matter caught between the display and exterior frame of the multi-display. OK: No foreign matt ...

Poor Sound Quality in All Modes (Low Volume)

PROCEDURE 1. CHECK AUDIO SETTINGS (a) Set treble, middle and bass to the initial values and check that the sound is normal. OK: The sound returns to normal. HIN ...

Other materials about Toyota Venza:

Speed Signal Circuit
DESCRIPTION The combination meter assembly receives the vehicle speed signal from this circuit. The wheel speed sensors produce an output that varies according to the vehicle speed. The wheel speed sensor output is received by the skid control ECU which u ...

Removal
REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system (See page ). NOTICE: When disconnecting the cable, s ...

AV Signal Stoppage (Low Battery Voltage) (B158F)
DESCRIPTION This DTC is stored when a video or audio signal is interrupted due to battery voltage input to the radio and display receiver assembly dropping temporarily. DTC No. DTC Detection Condition Trouble Area ...