Toyota Venza: Reassembly

Toyota Venza Service Manual / Mirror (ext) / Outer Rear View Mirror / Reassembly

REASSEMBLY

PROCEDURE

1. INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY

2. INSTALL OUTER MIRROR COVER

3. INSTALL OUTER MIRROR LIGHT ASSEMBLY

4. INSTALL OUTER MIRROR

Inspection

INSPECTION PROCEDURE 1. INSPECT OUTER REAR VIEW MIRROR ASSEMBLY RH (a) Check the operation of the mirror surface. (1) Disconnect the outer rear view mirror assembly RH connector. ...

Installation

INSTALLATION PROCEDURE 1. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY (a) Engage the 3 claws to install the outer rear view mirror assembly as shown in the illustration. ...

Other materials about Toyota Venza:

Short in Front Passenger Side Squib 2nd Step Circuit (B1815/54-B1818/54)
DESCRIPTION The front passenger side squib 2nd step circuit consists of the center airbag sensor assembly and front passenger airbag assembly. The center airbag sensor assembly uses this circuit to deploy the airbag when deployment conditions are met. T ...

Inspection
INSPECTION PROCEDURE 1. INSPECT FRONT DOOR LOCK ASSEMBLY LH (a) Check the operation of the door lock motor. (1) Apply battery voltage and check the operation of the door lock motor. OK: Measurement Condition ...

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT REAR COMBINATION LIGHT ASSEMBLY (a) Disconnect the connector from the rear combination light assembly. (b) Measure the voltage according to the value(s) in ...