Toyota Venza manuals

Toyota Venza: Problem Symptoms Table

PROBLEM SYMPTOMS TABLE

  • Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  • Inspect the fuses and relays related to this system before inspecting the suspected areas below.
Charging System

Symptom

Suspected Area

See page

Charge warning light comes on while driving

Generator clutch pulley


Generator assembly


Noise occurs from generator while engine is running

V-ribbed belt


Generator clutch pulley


Generator assembly


System Diagram
SYSTEM DIAGRAM ...

Charge Warning Light Comes ON while Driving
PROCEDURE 1. CHECK LOCK FUNCTION OF GENERATOR CLUTCH PULLEY (a) Check the lock function with the pulley installed in the vehicle. (1) Visually check that the rotor i ...

Other materials about Toyota Venza:

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Perform "Inspection After Repair" after replacing the engine assembly (See page ). PROCEDURE 1. INSTALL ENGINE HANGERS 2. REMOVE ENGINE STAND (a) Remove the engine stand. 3. INSTALL ENGINE WIRE ...

Dtc Check / Clear
DTC CHECK / CLEAR 1. CHECK DTCS (a) Turn the engine switch off. (b) Connect the Techstream to the DLC3. (c) Turn the engine switch on (IG). (d) Turn the Techstream on. (e) Check for DTCs. Enter the following menus: Body Electrical / Smart Key / Trouble ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL NO. 2 STEERING RACK BOOT (a) Apply lithium soap base glycol grease to the inside of the small opening of a new No. 2 steering rack boot. (b) Install the No. 2 ste ...

© 2016-2026 Copyright www.tovenza.com

0.1334