Toyota Venza manuals

Toyota Venza: Overhead console


Push the lid.

The overhead console is useful for temporarily storing small items.

CAUTION

 - While driving

Do not leave the overhead console open. Items may fall out and cause injury.

Console boxes
► Front Press the tab and slide to open. ► Rear 1. Pull up the lever to release the lock. 2. Slide the armrest fully rearward. 3. Lift the armrest to open.  - When using the ...

Cup holders
► Front ► Rear Pull down the armrest and open the lid.  - Adjusting size of the front cup holder Remove the adapter. CAUTION  - Items unsuitable for the cup holder D ...

Other materials about Toyota Venza:

Installation
INSTALLATION PROCEDURE 1. INSTALL YAW RATE AND ACCELERATION SENSOR (a) Install the yaw rate and acceleration sensor to the bracket with the 2 nuts. Torque: 5.0 N·m {51 kgf·cm, 44 in·lbf} ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL STIFFENING CRANKCASE RING PIN NOTICE: It is not necessary to remove the ring pin unless it is being replaced. (a) Using a plastic-faced hammer, tap in 2 new ring pins until they stop. Text in Illustration ...

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK TRANSPONDER KEY AMPLIFIER (a) Disconnect the D21 transponder key amplifier connector. (b) Measure the resistance according to the value(s) in the table below. HINT: Measure the values on the wire harness side with connector dis ...

© 2016-2026 Copyright www.tovenza.com

0.1789