Toyota Venza: Front Seat Frame With Adjuster

Installation

INSTALLATION PROCEDURE 1. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER (a) Using a tacker, install the separate type front seat cushion heater to the end of the separate type front ...

Inspection

INSPECTION PROCEDURE 1. INSPECT FRONT SEAT FRAME WITH ADJUSTER LH (a) Check operation of the seat frame (slide motor). (1) w/ Memory: Check if the seat frame moves smoothly when the ...

Other materials about Toyota Venza:

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. HINT: Using the T ...

Oxygen (A/F) Sensor Heater Control Circuit Low (Bank 1 Sensor 1) (P0031,P0032,P101D)
DESCRIPTION Refer to DTC P2195 (See page ). HINT: When any of these DTCs is stored, the ECM enters fail-safe mode. The ECM turns off the air fuel ratio sensor heater in fail-safe mode. Fail-safe mode continues until the ignition switch is t ...

Starter Relay Circuit High (P0617)
DESCRIPTION While the engine is being cranked, battery voltage is applied to terminal STA of the TCM. If the TCM detects the Starter Control (STA) signal while the vehicle is being driven, it determines that there is a malfunction in the STA circuit. The ...