Toyota Venza: Black Screen

Toyota Venza Service Manual / Audio / Video / Audio And Visual System / Black Screen

PROCEDURE

1.	CHECK DISPLAY SETTING

(a) Check that the display is not in screen off mode.

OK:

The display setting is not in screen off mode.

CHANGE SCREEN TO SCREEN ON MODE

2.	CHECK IMAGE QUALITY SETTING

(a) Check that the screen color quality can be set.

OK:

Setting is possible.

SET SCREEN COLOR QUALITY TO NORMAL

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Portable Player cannot be Registered

CAUTION / NOTICE / HINT HINT: Some versions of "Bluetooth" compatible audio players may not function properly, or the functions may be limited using the radio and display receiver assemb ...

USB Audio System Recognition/Play Error

DESCRIPTION When a USB device or "iPod" is connected to the USB jack of the No. 1 stereo jack adapter assembly, it must have playable files. The device must also communicate with and be ...

Other materials about Toyota Venza:

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE REAR DRIVE SHAFT SNAP RING (a) Using a screwdriver, remove the rear drive shaft snap ring. 2. REMOVE NO. 2 REAR DRIVE SHAFT INBOARD JOINT BOOT CLAMP (a) U ...

Locking the driver’s doors from the outside without a key
Move the inside lock button to the lock position. Close the door. ►Vehicles with smart key system The door cannot be locked if the “ENGINE START STOP” switch is in ACCESSORY or IGNITION ON mode, or the electronic key is left inside the vehic ...

Horn Circuit
DESCRIPTION When the theft deterrent system is switched from the armed state to the alarm sounding state, the main body ECU (driver side junction block assembly) transmits a signal to cause the horn to sound at intervals of 0.4 seconds. WIRING DIAGRAM ...