Toyota Venza: Customize Parameters

Toyota Venza Service Manual / Meter / Gauge / Display / Meter / Gauge System / Customize Parameters

CUSTOMIZE PARAMETERS

1. CUSTOMIZE METER / GAUGE SYSTEM

(a) Customizing with the Techstream

(1) Connect the Techstream to the DLC3.

(2) Turn the ignition switch to ON.

(3) Turn the Techstream on.

(4) Enter the following menus: Customize Setting / Warning.

(5) Select the setting by referring to the table below.

NOTICE:

Be sure to record the current value before customizing.

Combination Meter

Tester Display	Default	Content	Setting
Key Remind Volume	Large	Function to change the volume of the key reminder buzzer.	Large, Medium, Small
Key Remind Sound	Normal	Function to change the frequency of the key reminder buzzer.	Normal, Slow, Fast
Driver Side Seatbelt Warning Buzzer*1	ON	Function to turn on/off the seat belt warning buzzer.	ON or OFF
Front Passenger Side Seatbelt Warning Buzzer*1	ON	Function to turn on/off the seat belt warning buzzer.	ON or OFF

*1: This setting is only valid for the buzzer which sounds at 20 km/h (12 mph) or more.

System Description

SYSTEM DESCRIPTION 1. OUTLINE OF THE COMBINATION METER ASSEMBLY (a) Meter or Gauge Item Detail Speedometer Indicates the vehicle speed based on a ...

Problem Symptoms Table

PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptom are list ...

Other materials about Toyota Venza:

Fail-safe Chart
FAIL-SAFE CHART 1. POWER WINDOW OPERATION IN FAIL-SAFE MODE HINT: If the pulse sensor built into the power window regulator motor malfunctions, the power window control system enters fail-safe mode. (a) The power window control system prohibits the follo ...

Reporting safety defects for U.S. owners
If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTSA) in addition to notifying Toyota Motor Sales, U.S.A., Inc. (T ...

Removal
REMOVAL PROCEDURE 1. DRAIN DIFFERENTIAL OIL (a) Using a 10 mm hexagon wrench, remove the rear differential carrier cover plug and gasket. (b) Using a 10 mm hexagon wrench, remove the ...