CAUTION / NOTICE / HINT
HINT:
Some versions of "Bluetooth" compatible audio players may not function properly,
or the functions may be limited using the radio and display receiver assembly, even
if the portable audio player itself can play files (See page
).
PROCEDURE
|
1. |
CHECK THAT PORTABLE PLAYER IS "Bluetooth" AUDIO COMPATIBLE |
(a) Check if the portable player is "Bluetooth" audio compatible.
|
Result |
Proceed to |
|---|---|
|
The portable player is "Bluetooth" audio compatible. |
A |
|
The portable player is not "Bluetooth" audio compatible. |
B |
| B | |
USE A "Bluetooth" AUDIO COMPATIBLE PORTABLE PLAYER |
|
|
2. |
CHECK CONNECTION PROCEDURE OF CONNECTED DEVICE |
(a) Referring to Owner's Manual, correctly register the portable player.
(b) Check that the portable player has been registered as a connected device.
The portable player cannot be registered under any of the following conditions:
OK:
The portable player has been registered as a connected device.
| OK | |
END |
|
|
3. |
CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL |
(a) Check if the portable player can be registered normally to another "Bluetooth" audio compatible vehicle of the same model.
OK:
The portable player can be registered.
| NG | |
MALFUNCTION IN PORTABLE PLAYER |
|
|
4. |
REMOVE ADDITIONAL DEVICES WHICH USE RADIO WAVES |
(a) Remove additional devices which use radio waves.
(b) Place the portable player close to the radio and display receiver assembly.
(c) Check that the portable player can be registered as a connected device.
OK:
The portable player can be registered.
| OK | |
END |
| NG | |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
Registered Device cannot be Deleted
Black ScreenRemoval
REMOVAL
PROCEDURE
1. REMOVE COOL AIR INTAKE DUCT SEAL
(a) Using a clip remover, remove the 12 clips and cool air intake duct
seal.
2. REMOVE RADIATOR GRILLE
3. REMOVE FRONT BUMPER ASSEMBLY
...
Removal
REMOVAL
PROCEDURE
1. REMOVE REAR WHEELS
2. REMOVE CENTER EXHAUST PIPE ASSEMBLY
(a) Remove the center exhaust pipe assembly.
HINT:
Refer to the instructions for Removal of the exhaust pipe (See page
for 2GR-FE,
for 1AR-FE).
3. REMOVE PROPELLER WITH ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL ATF TEMPERATURE SENSOR ASSEMBLY
(a) Coat a new O-ring with ATF and install it to the ATF temperature
sensor assembly.
Text in Illustration
*1
O-ring
...