Toyota Venza manuals

Toyota Venza: ABS Control System Malfunction (43)

DESCRIPTION

This DTC is output when the VSC system detects a malfunction in the ABS control system.

DTC Code

DTC Detection Condition

Trouble Area

43

Malfunction in the ABS control system.

ABS control system

PROCEDURE

1.

CHECK ABS CONTROL SYSTEM

(a) Clear the DTCs (See page ).


(b) Turn the ignition switch to ON.

(c) Check if the same DTC is recorded (See page ).


Result

Proceed to

DTC (ABS control system DTC) is not output

A

DTC (ABS control system DTC) is output

B


B

REPAIR CIRCUITS INDICATED BY OUTPUT DTCS


A

2.

RECONFIRM DTC

(a) Turn the ignition switch off.

(b) Clear the DTCs (See page ).


(c) Start the engine.

(d) Drive the vehicle at a speed of approximately 40 km/h (25 mph) or more for 60 seconds or more.

(e) Check if the same DTC is recorded (See page ).


Result

Proceed to

DTC (43) is not output

A

DTC (43) is output

B


A

CHECK FOR INTERMITTENT PROBLEMS


B

REPLACE BRAKE ACTUATOR ASSEMBLY

SFR Solenoid Circuit (C0226/21,C0236/22,C0246/23,C0256/24,C1225/25-C1228/28)
DESCRIPTION These solenoids turn on when signals are received from the skid control ECU and they control the pressure acting on the wheel cylinders to control the braking force. DTC Cod ...

Rear Speed Sensor RH Circuit (C0210/33,C0215/34,C1273/73,C1274/74,C1332/38,C1333/39)
DESCRIPTION The speed sensor detects the wheel speed and sends the appropriate signals to the skid control ECU. These signals are used for the ABS control system. Speed sensor rotors have rows of ...

Other materials about Toyota Venza:

ECM / PCM Processor (P0606)
MONITOR DESCRIPTION The ECM continuously monitors its main and sub CPUs. This self-check ensures that the ECM is functioning properly. If outputs from the CPUs are different and deviate from the standard, the ECM illuminates the MIL and stores the DTC imm ...

Unmatched Encryption Code (B2794)
DESCRIPTION This DTC is stored when a key with an incomplete key code is inserted into the ignition key cylinder. DTC No. DTC Detection Condition Trouble Area B2794 Key with incomplete key code i ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL TRANSFER DRIVEN PINION REAR BEARING (a) Using SST and a press, press the transfer driven pinion rear bearing (outer race) to the case. SST: 09950-60010 09951-00620 SST: 09950-70010 09951-07150 NO ...

© 2016-2026 Copyright www.tovenza.com

0.1172