Toyota Venza: Rear Seat Assembly(for Lh Side)

Installation

INSTALLATION PROCEDURE 1. INSTALL POWER SEAT SWITCH (a) Install the power seat switch with the 3 screws. (b) Connect the connector. 2. IN ...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Locking the driver’s doors from the outside without a key
Move the inside lock button to the lock position. Close the door. ►Vehicles with smart key system The door cannot be locked if the “ENGINE START STOP” switch is in ACCESSORY or IGNITION ON mode, or the electronic key is left inside the vehic ...

Installation
INSTALLATION PROCEDURE 1. INSTALL REAR DOOR COURTESY LIGHT SWITCH (a) Using "TORX" socket wrench T30, install the rear door courtesy light switch with the "TORX" bolt. Torque: 8.0 N·m {82 kgf·cm, 71 in·lbf} ...

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL DOOR SIDE AIRBAG SENSOR (a) Check that the ignition switch is off. (b) C ...