Toyota Venza: Installation
INSTALLATION
PROCEDURE
1. INSTALL NO. 2 COOLING FAN MOTOR
|
(a) Install the No. 2 cooling fan motor with the 3 screws. Torque: w/o Towing package : 2.6 N·m {26 kgf·cm, 23 in·lbf} w/ Towing package : 3.9 N·m {40 kgf·cm, 35 in·lbf} |
|
.png)
|
(b) Connect the No. 2 cooling fan motor connector and 2 clamps. |
|
.png)
2. INSTALL COOLING FAN MOTOR
|
(a) Install the cooling fan motor with the 3 screws. Torque: w/o Towing package : 2.6 N·m {26 kgf·cm, 23 in·lbf} w/ Towing package : 3.9 N·m {40 kgf·cm, 35 in·lbf} |
|
.png)
3. INSTALL COOLING FAN MOTOR INSULATOR
|
(a) Install the cooling fan motor insulator with the 2 bolts. Torque: 2.6 N·m {26 kgf·cm, 23 in·lbf} |
|
.png)
4. INSTALL NO. 2 FAN
|
(a) Install the No. 2 fan with the nut. Torque: 6.3 N·m {64 kgf·cm, 56 in·lbf} |
|
.png)
5. INSTALL FAN
|
(a) Install the fan with the nut. Torque: 6.3 N·m {64 kgf·cm, 56 in·lbf} |
|
.png)
6. INSTALL RADIATOR ASSEMBLY AND FAN ASSEMBLY WITH MOTOR
HINT:
See page .gif)
Removal
REMOVAL
PROCEDURE
1. REMOVE RADIATOR ASSEMBLY AND FAN ASSEMBLY WITH MOTOR
HINT:
See page
2. REMOVE FAN
(a) Remove the nut and fan.
3. ...
Other materials about Toyota Venza:
Removal
REMOVAL
PROCEDURE
1. DRAIN AUTOMATIC TRANSAXLE FLUID
2. REMOVE FRONT FRAME ASSEMBLY
See page
3. SUPPORT ENGINE ASSEMBLY
4. REMOVE BELT
5. REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY
(a) Remove the 18 bolts and automatic transa ...
Seat Heater Switch
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
2. REMOVE SEAT HEATER SWITCH
(a) Disengage the 2 claws and remove the seat heater switch as shown
in the illustration.
...
Oxygen Sensor Heater Control Circuit Low (Bank 1 Sensor 2) (P0037,P0038,P0141,P102D)
DESCRIPTION
Refer to DTC P0136 (See page ).
HINT:
When any of these DTCs are stored, the ECM enters fail-safe mode. The
ECM turns off the heated oxygen sensor heater in fail-safe mode. Fail-safe
mode continues until the ignition switch is t ...
0.1317