Toyota Venza: Cooling Fan Motor

Coolant

Replacement REPLACEMENT PROCEDURE 1. REMOVE NO. 1 ENGINE UNDER COVER 2. REMOVE NO. 2 ENGINE UNDER COVER 3. DRAIN ENGINE COOLANT (a) Loosen the radiator drain cock plug and drain the coolant. ...

Components

COMPONENTS ILLUSTRATION ...

Other materials about Toyota Venza:

Check Mode Procedure
CHECK MODE PROCEDURE 1. CHECK MODE (SIGNAL CHECK): DTC CHECK (a) Turn the ignition switch off. (b) Connect the Techstream to the DLC3. (c) Turn the ignition switch to ON. (d) Turn the Techstream on. (e) Enter the following menus: Body Electrical / SRS Ai ...

Checking and replacing fuses
If any of the electrical components do not operate, a fuse may have blown. If this happens, check and replace the fuses as necessary. Vehicles with smart key system: Turn the “ENGINE START STOP” switch off. Vehicles without smart key system: Turn th ...

Transfer Case Rear Oil Seal
Components COMPONENTS ILLUSTRATION ILLUSTRATION Replacement REPLACEMENT PROCEDURE 1. REMOVE TAIL EXHAUST PIPE ASSEMBLY 2. REMOVE CENTER EXHAUST PIPE ASSEMBLY 3. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY 4. REMOVE TRANSFER C ...