Toyota Venza: Camshaft Oil Control Valve

Air Fuel Ratio Sensor

Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY 2. REMOVE COOL AIR INTAKE DUCT SEAL 3. REMOVE INLET AIR CLEANER ASSEMBLY ...

Components

COMPONENTS ILLUSTRATION ...

Other materials about Toyota Venza:

Installation
INSTALLATION PROCEDURE 1. INSTALL REAR DOOR LOCK ASSEMBLY NOTICE: When reusing the removed rear door lock assembly, replace the door lock wiring harness seal on the connector with a new one. Do not allow grease or dust to adhere to the door ...

Adjustment
ADJUSTMENT PROCEDURE 1. INSPECT SHIFT LEVER POSITION (a) When moving the lever from P to R with the ignition switch ON and the brake pedal depressed, make sure that the shift lever moves smoothly and moves correctly into position. (b) Start the engine ...

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK POWER BACK DOOR ECU (POWER BACK DOOR MOTOR UNIT) (a) Disconnect the L20 ECU connector. (b) Measure the voltage and resistance according to the value(s) in the table below. Tester Connection Wiring Color ...