Toyota Venza: Brake Booster

Brake System (other)

...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Oxygen (A/F) Sensor Heater Control Circuit Low (Bank 1 Sensor 1) (P0031,P0032,P101D)
DESCRIPTION Refer to DTC P2195 (See page ). HINT: When any of these DTCs is stored, the ECM enters fail-safe mode. The ECM turns off the air fuel ratio sensor heater in fail-safe mode. Fail-safe mode continues until the ignition switch is t ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE TRANSPONDER KEY ECU ASSEMBLY (w/ Engine Immobiliser System) 2. REMOVE NO. 1 FINISH PANEL MOUNTING BRACKET (a) Remove the 2 bolts and 2 No. 1 finish panel mounting brackets as shown in the illustration. ...

Replacement
REPLACEMENT PROCEDURE 1. REPLACE RING PIN NOTICE: It is not necessary to remove the ring pin unless it is being replaced. (a) Remove the 12 ring pins. (b) Using a plastic-faced hammer, install 12 new ring pins. Standard Protrusion Height: ...