DESCRIPTION
This DTC is stored when a key with a key code that has not been registered in the ECU is inserted into the ignition key cylinder.
|
DTC No. |
DTC Detection Condition |
Trouble Area |
|---|---|---|
|
B2795 |
Key with unregistered key code is inserted. |
Key |
CAUTION / NOTICE / HINT
NOTICE:
If the key is replaced, register the key (See page
).
PROCEDURE
|
1. |
CLEAR DTC |
(a) Clear the DTCs (See page
).
|
|
2. |
RE-REGISTER KEY |
(a) Re-register the key (See page
).
|
|
3. |
CHECK ENGINE START |
(a) Check that the engine starts.
OK:
The engine starts.
| OK | |
END (KEY WAS NOT REGISTERED CORRECTLY) |
| NG | |
REPLACE KEY |
Transponder Chip Malfunction (B2793)
Unmatched Encryption Code (B2794)Adjustment
ADJUSTMENT
CAUTION / NOTICE / HINT
HINT:
Centering bolts are used to mount the hood hinge and hood lock. The
hood and hood lock cannot be adjusted with the centering bolts installed.
Substitute the centering bolts with standard bolts when ...
Route cannot be Calculated
PROCEDURE
1.
SET DESTINATION
(a) Set another destination and check if the system can calculate the route correctly.
OK:
Route can be correctly calculated.
OK
END
NG
PROCEED T ...
Gauges and meters
►Vehicles with smart key system
The following gauges, meters and display illuminate when the “ENGINE START STOP”
switch is in IGNITION ON mode.
►Vehicles without smart key system
The following gauges, meters and displays illuminate when ...