Toyota Venza: Steering Pad

Installation

INSTALLATION PROCEDURE 1. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY NOTICE: Do not replace the spiral cable with the battery connected and the ignition switch on (IG). Do not r ...

Components

COMPONENTS ILLUSTRATION ...

Other materials about Toyota Venza:

Removal
REMOVAL PROCEDURE 1. REMOVE FRONT WIPER ARM HEAD CAP (a) Using a screwdriver, remove the 2 front wiper arm head caps as shown in the illustration. Text in Illustration *1 Protective Tape ...

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. The rear speed sensor is a component of the rear axle hub and bearing assembly. If the sensor malf ...

Brake Switch "B" Circuit High (P0724)
DESCRIPTION The purpose of this circuit is to prevent the engine from stalling when the brakes are suddenly applied while driving in the lock-up condition. When the brake pedal is depressed, this switch sends a signal to the TCM. Then the TCM cancels the ...