Toyota Venza: Specifications

Vehicle specifications

Maintenance data (fuel, oil level, etc.)

Other materials about Toyota Venza:

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE PROPELLER SHAFT (a) Place matchmarks on both flanges. Text in Illustration *1 Matchmark (b) Remove the 4 nuts, ...

Installation
INSTALLATION PROCEDURE 1. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY (a) Check that the ignition switch is off. (b) Check that the cable is disconnected from the negative (-) battery terminal. CAUTION: Wait at least 90 seconds after disconnecting the cable ...

Removal
REMOVAL CAUTION / NOTICE / HINT CAUTION: Wear protective gloves when removing the exhaust pipe. The exhaust pipe is extremely hot immediately after the engine has stopped. Confirm that the exhaust pipe has cooled down ...