Toyota Venza: Removal

Toyota Venza Service Manual / Seat / Lumbar Switch / Removal

REMOVAL

PROCEDURE

1. REMOVE FRONT SEAT HEADREST ASSEMBLY

2. REMOVE FRONT SEAT REAR OUTER TRACK COVER

3. REMOVE FRONT SEAT REAR INNER TRACK COVER

4. REMOVE FRONT SEAT ASSEMBLY

5. REMOVE RECLINING POWER SEAT SWITCH KNOB

6. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

7. REMOVE FRONT SEAT CUSHION SHIELD ASSEMBLY

8. REMOVE FRONT POWER SEAT LUMBAR SWITCH

(a) Remove the 2 screws and the front power seat lumbar switch.

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ...

Inspection

INSPECTION PROCEDURE 1. INSPECT DRIVER SIDE LUMBAR SWITCH (a) Measure the resistance between the terminals when the switch is operated. Standard Resistance: Teste ...

Other materials about Toyota Venza:

Components
COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Drive Belt
Components COMPONENTS ILLUSTRATION On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT V-RIBBED BELT (a) Check the belt for wear, cracks or other signs of damage. If any of the following defects is found, replace the V-r ...

Steering Knuckle
Components COMPONENTS ILLUSTRATION Removal REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE FRONT AXLE ASSEMBLY HINT: ...