Toyota Venza: Reassembly

Toyota Venza Service Manual / Interior Panels / Trim / Instrument Panel Safety Pad / Reassembly

REASSEMBLY

PROCEDURE

1. INSTALL NO. 1 INSTRUMENT PANEL PIN

(a) Install the 2 No. 1 instrument panel pins with the 2 screws <E> or <F>.

2. INSTALL GLOVE BOX LIGHT ASSEMBLY

(a) Engage the 2 claws to install the glove box light assembly.

3. INSTALL FRONT PASSENGER AIRBAG ASSEMBLY

4. INSTALL NO. 3 INSTRUMENT PANEL WIRE

(a) Engage the 4 clamps to install the No. 3 instrument panel wire.

5. INSTALL NAVIGATION ANTENNA ASSEMBLY (w/ Navigation System)

6. INSTALL NO. 1 ANTENNA CORD SUB-ASSEMBLY

7. INSTALL HEATER TO REGISTER DUCT

(a) Install the heater to register duct with the 7 screws <E> or <F>.

8. INSTALL DEFROSTER NOZZLE ASSEMBLY

(a) Install the defroster nozzle assembly with the 4 screws <E> or <F>.

9. INSTALL NO. 2 SIDE DEFROSTER NOZZLE DUCT

(a) Install the No. 2 side defroster nozzle duct with the 2 screws <E> or <F>.

10. INSTALL NO. 1 SIDE DEFROSTER NOZZLE DUCT

(a) Install the No. 1 side defroster nozzle duct with the 2 screws <E> or <F>.

Disassembly

DISASSEMBLY PROCEDURE 1. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT (a) Remove the 2 screws <E> or <F> and remove the No. 1 side defroster nozzle duct. ...

Installation

INSTALLATION PROCEDURE 1. INSTALL INSTRUMENT PANEL STAY (a) Engage the 3 claws to install the 3 instrument panel stays. 2. INSTALL INSTRUM ...

Other materials about Toyota Venza:

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" ...

Electrical Key Oscillator(for Rear Floor)
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) 2. REMOVE DECK BOARD ASSEMBLY 3. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY 4. REMOVE DECK SIDE TRIM BOX LH 5. REMOVE NO. 2 D ...

Inspection
INSPECTION PROCEDURE 1. INSPECT COMPRESSOR WITH PULLEY (SOLENOID VALVE) (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition ...