Toyota Venza: Rear Seat Inner Belt Assembly(for Lh Side)

Installation

INSTALLATION PROCEDURE 1. INSTALL REAR CENTER SEAT OUTER BELT ASSEMBLY (a) Install the rear center seat outer belt assembly with the bolt and nut. Torque: Bolt : 7.5 N·m ...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

TC and CG Terminal Circuit
DESCRIPTION DTC output mode is set by connecting terminals TC and CG of the DLC3. DTCs are displayed by blinking of the SRS warning light. HINT: When each warning light stays blinking, a ground short in the wiring of terminal TC of the DLC3 or ...

Brake Switch "B" Circuit High (P0724)
DESCRIPTION The purpose of this circuit is to prevent the engine from stalling when brakes are suddenly applied while driving in lock-up condition. When the brake pedal is depressed, the stop light switch sends a signal to the ECM. Then the ECM cancels t ...

If the battery is discharged
The following procedures may be used to start the engine if the battery is discharged. You can call your Toyota dealer or qualified repair shop. If you have a set of jumper (or booster) cables and a second vehicle with a 12 volt battery, you can jump sta ...