Toyota Venza: Rear Crankshaft Oil Seal

Front Crankshaft Oil Seal

Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE FRONT WHEEL RH 2. REMOVE NO. 1 ENGINE UNDER COVER 3. SEPARATE FRONT FENDER LINER RH 4. REMOVE FRONT FENDER APRON S ...

Components

COMPONENTS ILLUSTRATION ...

Other materials about Toyota Venza:

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL TRANSFER DRIVEN PINION REAR BEARING (a) Using SST and a press, press the transfer driven pinion rear bearing (outer race) to the case. SST: 09950-60010 09951-00620 SST: 09950-70010 09951-07150 NO ...

4WD Control ECU Communication Stop Mode
DESCRIPTION Detection Item Symptom Trouble Area 4WD Control ECU Communication Stop Mode "Four Wheel Drive Control" is not displayed on the "CAN Bus Check" screen ...

ABS Warning Light Remains ON
DESCRIPTION The skid control ECU is connected to the combination meter via CAN communication. If any of the following is detected, the ABS warning light remains on: The skid control ECU connector is disconnected from the skid control ECU. The ...