Toyota Venza manuals

Toyota Venza: Outside rear view mirrors

Mirror angle can be adjusted using the switch.


Select a mirror to adjust.

1. Left
2. Right


Adjust the mirror.

1. Up
2. Right
3. Down
4. Left

Automatic anti-glare function
Responding to the level of brightness of the headlights of vehicles behind, the reflected light is automatically reduced. Changing automatic anti-glare function mode ON/OFF When the automatic an ...

Folding back the mirrors (power type)
Press the switch to fold the mirrors. Press it again to extend them to the original position. ...

Other materials about Toyota Venza:

Short in Driver Side Squib 2nd Step Circuit (B1810/53-B1813/53)
DESCRIPTION The driver side squib 2nd step circuit consists of the center airbag sensor assembly, spiral cable and steering pad. The center airbag sensor assembly uses this circuit to deploy the airbag when deployment conditions are met. These DTCs are ...

Installation
INSTALLATION CAUTION / NOTICE / HINT CAUTION: The nuts must not be reused. Make sure that the front seat frame assembly with adjuster is not deformed. If it is, replace it with a new one. PROCEDURE 1. INSTALL FRONT SEAT SIDE AIRBAG A ...

Removal
REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 2. REMOVE RADIATOR RESERVE TANK ASSEMBLY (a) Remove t ...

© 2016-2026 Copyright www.tovenza.com

0.1594