Toyota Venza: On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY
(a) for RH Side
|
(1) Operate the windshield wiper motor assembly. |
|
(2) Stop the windshield wiper motor assembly operation.
(3) Check the automatic stop (park) position.
OK:
The front wiper stops at the position shown in the illustration.
(b) for LH Side
|
(1) Operate the windshield wiper motor assembly. |
|
(2) Stop the windshield wiper motor assembly operation.
(3) Check the automatic stop (park) position.
OK:
The front wiper stops at the position shown in the illustration.
Text in Illustration|
*1 |
Ceramic Notch |
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
...
Inspection
INSPECTION
CAUTION / NOTICE / HINT
NOTICE:
Ensure that fingers or articles of clothing do not get caught in moving parts
when performing this test.
PROCEDURE
1. INSPECT WINDSHIELD WIPER MOTOR A ...
Other materials about Toyota Venza:
Transponder Chip Malfunction (B2793)
DESCRIPTION
This DTC is stored when a malfunction is found in the key during key code registration
or a key code is not registered normally. Replace the key if the key code registration
is not performed normally and this DTC is detected.
DTC N ...
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE REAR DRIVE SHAFT SNAP RING
(a) Using a screwdriver, remove the rear drive shaft snap ring.
2. REMOVE NO. 2 REAR DRIVE SHAFT INBOARD JOINT BOOT CLAMP
(a) U ...
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use this procedure to troubleshoot the theft deterrent system.
*: Use the Techstream.
PROCEDURE
1.
VEHICLE BROUGHT TO WORKSHOP
NEXT
...
0.1248