Toyota Venza: Lost Communication with Automatic High Beam Sensor (B2432)

Toyota Venza Service Manual / Networking / Lin Communication System / Lost Communication with Automatic High Beam Sensor (B2432)

DESCRIPTION

Refer to DTC B2432 (Lighting system) (See page ).

DTC No.	DTC Detection Condition	Trouble Area
B2432	Malfunction in LIN communication system	Inner rear view mirror assembly Harness or connector AFS ECU (headlight swivel ECU assembly)

WIRING DIAGRAM

Refer to DTC B2432 (Lighting system) (See page ).

PROCEDURE

1.	REFER TO DTC B2432 (Lighting system)

See page

END

No Response from Steering Lock ECU (B2786)

DESCRIPTION This DTC is stored when LIN communication between the certification ECU (smart key ECU assembly) and steering lock ECU (steering lock actuator assembly) stops for more than 10 seconds ...

Communication Malfunction between ECUs Connected by LIN (B2785)

DESCRIPTION This DTC is stored when LIN communication from the certification ECU stops for a certain amount of time. DTC No. DTC Detection Condition Trouble Area ...

Other materials about Toyota Venza:

Room Temperature Sensor
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 2. REMOVE FR ...

Trouble in Passenger Airbag ON/OFF Indicator
DESCRIPTION The occupant classification system detects the front passenger seat condition. It then informs a passenger of the front passenger airbag assembly and front seat belt pretensioner RH condition (activated/not activated) with the passenger airbag ...

Open in Rear Floor Electrical Key Oscillator Circuit (B27A6)
DESCRIPTION The certification ECU (smart key ECU assembly) generates a request signal and sends it to the indoor electrical key oscillator (for center floor). To detect the key inside the cabin, the indoor electrical key oscillator (for center floor) crea ...