Toyota Venza: Installation

Toyota Venza Service Manual / Brake Control / Dynamic Control Systems / Steering Angle Sensor / Installation

INSTALLATION

PROCEDURE

1. INSTALL SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY

(a) Install the spiral with sensor cable sub-assembly (See page ).

NOTICE:

Do not replace the spiral cable with the battery connected and the engine switch on (IG).
Do not rotate the spiral cable with the battery connected and the engine switch on (IG).
Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.
Do not remove the steering sensor from the spiral cable.
Never use the steering angle sensor detached from spiral cable.

HINT:

The steering angle sensor is a component of the spiral with sensor cable sub-assembly. If the steering angle sensor malfunctions, replace the spiral with sensor cable sub-assembly.

2. INSTALL UPPER STEERING COLUMN COVER

3. INSTALL LOWER STEERING COLUMN COVER

4. ADJUST SPIRAL CABLE

5. INSTALL STEERING WHEEL ASSEMBLY

6. INSPECT STEERING WHEEL CENTER POINT

7. INSTALL STEERING PAD

8. INSTALL LOWER NO. 3 STEERING WHEEL COVER

9. INSTALL LOWER NO. 2 STEERING WHEEL COVER

10. INSPECT STEERING PAD

11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

12. INSPECT SRS WARNING LIGHT

Removal

REMOVAL CAUTION / NOTICE / HINT NOTICE: Do not remove the steering angle sensor from the spiral cable. HINT: The steering angle sensor is a component of the spiral with sensor cable sub-assembly. ...

Other materials about Toyota Venza:

Sound of Portable Player cannot be Heard from Speakers or Sound is Low
PROCEDURE 1. CHECK PORTABLE PLAYER SETTINGS (a) Check the portable player settings. (1) Check that the volume is not set to "0". (2) Check that mute is off. (b) Check that the sound of the portable player can be h ...

How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT: Use the following procedure to troubleshoot the navigation system. *: Use the Techstream. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEXT ...

Removal
REMOVAL PROCEDURE 1. REMOVE FRONT SEAT HEADREST ASSEMBLY 2. REMOVE FRONT SEAT REAR OUTER TRACK COVER 3. REMOVE FRONT SEAT REAR INNER TRACK COVER 4. REMOVE FRONT SEAT ASSEMBLY 5. REMOVE RECLINING POWER SEAT SWITCH KNOB 6. REMOVE SLIDE AND VER ...

Toyota Venza: Installation

Components

Removal

Other materials about Toyota Venza: